Least Visible Trailer Hitch Receiver on a 2018 Ford Escape
Published 12/29/2017 >
Products Featured in This Question
Question:
Please tell me which 2inch hitch would be the best to buy that shows the least when installed on the car. Thank you!
asked by: Shar M
Expert Reply:
Out of the hitches that fit your 2018 Ford Escape the one that shows the least is the Draw-Tite, part # 75782, although not by a lot. It's designed so that the cross tube is tucked behind the bumper and then the receiver opening is all you see. The opening then sits about 1-3/4 inches recessed from the rear bumper. The other Draw-Tite hitch, part # 75758, shows the complete cross tube so it's the most visible.
However, the Curt, part # C13186, also hides the cross tube but the receiver tube is about 1 inch closer to the edge of the bumper compared to the # 75782.
Keep in mind these measurements are with the hitch installed on a 2017 model so they could be slightly different. The main takeaway is that you're not going to have much difference between the Curt and Draw-Tite hitches that have the hidden cross tube. Between the two of them, I recommend the Draw-Tite, # 75782, because it's slightly less visible.
I've linked videos of all 3 hitches being installed for you.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 350 lbs TW
- 3500 lbs GTW
- 5000 lbs WD GTW
- 2 Inch Hitch
- 500 lbs WD TW
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Shop: Trailer Hitch
- Q&A: Inverter for Use with Go Power 200 Watt Solar Panel Kit 34282181
- Q&A: Trailer Hitch and Wiring Recommendation for 2015 Ford Escape
- Q&A: Trailer Hitch Recommendation for 2015 Ford Escape SE with Best Towing Capacity
- Article: Best Bike Racks for Electric Bikes
- Q&A: Availability of Lionshead Black Bearcat Wheel
- Q&A: Recommended Route for Power Wire on a 2015 Ford Escape with Fuse Panel at the Rear
- Q&A: Is Heat Shield Trimming Required for Install of Curt Hitch part # C13186 on 2016 Ford Escape
- Q&A: Replacement Hitch Installation Hardware Kit for Curt C13186 for 2013-2019 Ford Escape
- Article: My Trailer Hitch Doesn't Fit
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Roof Rack Information
- Article: How Much Does a Boat and Trailer Weigh?
- Article: How to Measure for Trailer Hitch Drop




