Is Drilling Required to Install a Curt Trailer Hitch # C12051 on a 2009 Saturn Aura
Updated 06/13/2011 | Published 06/10/2011
Products Featured in This Question
Question:
For a 2009 Saturn Aura 2.4L, is there any drilling required?
asked by: Randy P
0
Expert Reply:
Yes, you will need to drill two 1/2 inch holes through the frame rail of your 2009 Saturn Aura 2.4L to install this Curt Trailer Hitch # C12051. I attached installation instructions for you to check out also.
You may be interested in the following products to complete your towing setup:
Class II drawbar # C45522
Pin and Clip # F-4
Hitch ball with 2 inch diameter # 19258
Hitch ball with 1-7/8 inch diameter # 19256
Curt custom fit vehicle wiring # C59236 (installation instructions attached)
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class II - 1-1/4"
- Trailer Hitch
- For Towing
- Class II
- 300 lbs TW
- 3500 lbs GTW
- 1-1/4 Inch Hitch
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Availability of Timbren Rear Suspension Kit that Fits 2026 Toyota Tundra
- Q&A: Best 7-Way Wiring Harness For 2017 Honda Pilot
- Article: Trailer Hitch Installation Tips
- Q&A: Available Drawbars for 1-1/4 Inch Hitches with at Least a 5-inch Rise in the Shank
- Q&A: Recommended Trailer Hitch For A 2022 Honda Accord Hybrid
- Q&A: 2021 Honda Accord Hybrid Model Trailer Hitch Fitment
- Q&A: Can a 1-7/8 inch Hitch Ball be Used with a 2 inch Coupler on Trailer
- Q&A: What is Needed to Wire a 2007 Saturn Aura for Flat Towing Behind a Motor Home
- Article: My Trailer Hitch Doesn't Fit