What is the Small Nub on Washer Spindle Tongue, # 165863, and What Does it Do
Published 06/09/2011
Question:
The spindle washer, on internal diameter has an extra projection or neck at one point, what is that projection technically called? whats the use of that small metal projection on internal diameter of spindle washer?
asked by: Shivaprasad T
0
Expert Reply:
On the Spindle washer, # 1655863, that little nub on the inside is called the tongue. It is designed to prevent the washer from spinning and wearing out.
expert reply by:
Michael H
0
Product Page this Question was Asked From
Continue Researching
- Q&A: Material of D Washer for EZ Lube Spindle
- Article: What RV AC Will Work With Your Setup? Avoid Costly Mistakes Before You Order
- Q&A: Replacement Trailer Taillight Lens that is SAE Number 2 AS2T2I6
- Q&A: Parts Needed to Flat Tow a 2013-2015 Smart Fortwo
- Q&A: Adding a Second Furrion Solar Panel FR73SR to RV Power System
- Q&A: Replacement Trailer Hubs For Spindle That Uses 1-1/4" Inner Bearing and 3/4" Outer Bearing
- Q&A: Replacement Bearings and Seal for Dexter Hub 8-147
- Q&A: Should There Be a Washer on Trailer Spindle Between Spindle Nut and Outer Bearing
- Article: Performance Chips and Modules
- Article: Trailer Wiring Diagrams
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Dealer Spotlight - Trailers of the East Coast
- Article: Trailer Lighting Requirements