Hole Size Required to Install Valterra Electrical Cable Hatch for RVs A10-2137VP
Updated 10/31/2017 | Published 10/30/2017
Products Featured in This Question
Question:
What is the width of the cutout cup ... it says 3 1/2inch but I have discovered that many are much smaller than that. My cutout is 2 27/32. Do you have one that size and a diameter of 4 1/2?
asked by: Tom M
Expert Reply:
I went to our warehouse and measured the Valterra Electrical Cable Hatch for RVs # A10-2137VP to get you the key dimensions you need.
The overall diameter of the mounting flange is 4-1/2-inches.
The hole size required for this item is 3-3/8-inches to 3-1/2-inches.
Required mounting depth (behind the flange) is 2-3/8-inches.
Similar part # A10-2140VP is closer to your dimensions but please note this is sized for 30-amp wiring.
Product Page this Question was Asked From
Valterra Electrical Cable Hatch for RVs - 4-9/16" Diameter - White
- RV Access Doors
- Electrical Cable Hatch
- Round
- Open Back
- 3 Inch Wide Cutout
- White
- Valterra
more information >
Continue Researching
- Q&A: Replacement gears for Lippert Landing Gear Instructions and Diagram
- Q&A: Which Roof Rack Will Work On My 2020 Jeep Cherokee With Black Factory Roof Rails?
- Article: 5 Products You Need For Your Next Camping Trip (2022)
- Article: How to Determine Tire/Wheel Diameter
- Q&A: Difference Between Mini Mod Trailer Rim and Non-Mini Mod Trailer Wheel
- Article: Printable Trailer Bolt Hole Pattern Template
- Q&A: Will the Mighty Cord Hardwire RV Plug A10-P30VP Fit Inside a Standard RV Power Cord Hatch
- Q&A: Recommended Replacement for Magnadyne LS7600CDW Stereo
- Q&A: What is the Difference Between Load Range C and D ST175/80D13 Trailer Tires
- Q&A: How To Install A 2-5/16 Inch Hitch Ball To A Draw Bar That Has Limited Access to the Hitch Ball Nut
- Article: Trailer Lighting Requirements
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Tire Sizing