Parts Needed to Install Brake Controller in 2016 Lexus RX 350

Updated 10/23/2017 | Published 10/22/2017

Products Featured in This Question

Tekonsha Prodigy P2 Trailer Brake Controller - 1 to 4 Axles - Proportional

(2763)

$159.00

10 Gauge Wire - Blue Primary - Per Foot

(104)

$1.84

Wiring Kit for 2, 4, 6, and 8 Brake Electric Trailer Brake Controllers

(159)

$56.26

Question:

Does a 2016 Lexus RX 350 with factory trailer tow package have a prewired connector for brake controller? if so is there a connector in the rear to connect the 7 pin connector? Thanks

asked by: Alan R

Expert Reply:

We do not have a plug and play install harness for installing a brake controller in a 2016 Lexus RX 350 but we do have a way for you to install one.

First let's start with a brake controller. I would recommend the Prodigy P2 Brake Controller part # 90885. This is our best selling brake controller because of how well it works and how easy it is to set up.

Next, for a wiring kit to install the brake controller to the 7-way you would want the Wiring Kit for 2 and 4 Brake Electric Brake Controllers # 5506. This will provide the power source and ground for the wiring for the brake controller. You will need to test the wires from the brake pedal switch of your vehicle to find a circuit that has voltage when the brakes are applied and none when not applied. This will be the circuit you will run the red wire to.

Finally you will need to run a length of 10 gauge wire (part # 10-1-1) from the brake output circuit of the controller to the brake output circuit of the 7-way (blue wire). The # 10-1-1 is sold by the foot so you will need to order a quantity of the amount of feet you will need.

I attached an FAQ on installing brake controllers for you to check out.