Using Safety Cables or Chains with Titan Swing Away Actuator on Trailer
Updated 10/20/2017 | Published 10/19/2017
Products Featured in This Question
Question:
I purchased a titan T4839100 swing away actuator and also the coil up safety cables where and how do I mount the cables
asked by: Larry T
0
Expert Reply:
Safety chains and cables, such as the Curt Single Hook # C80136, are generally attached to the trailer itself and not the coupler.
If your trailer does not have any good mounts on which to attach the cables, you can install some like the Brophy Mounting Bracket # MB12.
I have attached a short video demonstration on this part that you can also check out.
expert reply by:
Chris R
0
Product Page this Question was Asked From
Curt Single Hook, Coiled Safety Cables with S-Hooks - 42" Long - 3,500 lbs - Qty 2
- Safety Cables
- Coiled Cables
- 42 Inch Long
- 3500 lbs GTW
- S-Hooks
- Coated Cables
- CURT
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: What Is Speed Rating of the Kenda Bias Trailer Tire and Wheel # AM30156
- Q&A: How is Winch Strap of Fulton F2 Winch Accessed to Remove it.
- Q&A: Which Replacement Winch Strap Is Correct For the Fulton F2 2-Speed Winch FW32000101
- Q&A: Replacement Ratchet Spring and Install Diagram for Fulton F2 Winch
- Q&A: Are Leaf Spring Measured When Loaded Or Unloaded?
- Q&A: How Far do Trailer Springs Typically Compress
- Q&A: Replacement Grease Seal For Seal Marked TBY 42.77 65.07 12.7
- Article: RV Pre-Departure Checklist
- Article: How Level Should a Tow Bar Be When Flat Towing
- Article: Sidewinder with Rotating Turret for Short Bed Pickups
- Article: Can You Flat Tow a Ford Escape?
- Article: RV Roof Types: What Type of Roof Does My RV Have?
- Article: Trailer Lighting Requirements
- Article: How Much Solar Power Do I Need For My RV?