Fulton T1500 Winch Spring Replacement Installation Instructions
Updated 10/20/2017 | Published 10/19/2017 >
Question:
Can figure out how to install the spring to the winch.
asked by: Eric B
0
Expert Reply:
I have attached the instructions sheet for the Fulton hand winches that shows how to replace the ratchet spring. The correct part number is # 4769-28.
Basically, you will need to remove the bolt holding the ratchet pawl in place. Be sure to note how it came apart because there will be about 7 pieces total. On the spring, there is a narrow end and a wide end. The wide end hooks into the ratchet pawl and the narrow end hooks to the winch frame.
expert reply by:
Jameson C
0
Continue Researching
- Q&A: Ratchet Repair Kit For Fulton Winch 142104
- Shop: BoatBuckle G2 Retractable, Ratcheting Transom Tie-Down Straps - 43" Long - 833 lbs - Qty 2
- Shop: Miro-Flex LED Trailer Light w/ Reflector - Brake, Tail, Turn - Submersible - Oval - Red
- Shop: Optronics Fleet LED Trailer Tail Lights w/ Grommets - Stop,Turn,Tail - Submersible - Oval - Qty 2
- Shop: Winch Ratchet Repair Kit by Dutton-Lainson
- Q&A: Replacement LED Version of Trailer Light STIPP2R97
- Q&A: Is 4769-28 The Correct Replacement Spring for a Fulton T1802 Hand Winch
- Shop: Identification Light Bar for Trucks and Trailers - Weatherproof - Incandescent - Red Lens
- Search Results: trailer tires and wheels
- Shop: Trailer Hitch
- Shop: Demco Trailer Coupler - Cast - Adjustable Channel - eZ-Latch - Black - 2-5/16" Ball - 21K
- Shop: Optronics LED Trailer Light - Brake, Tail, Turn - Submersible - Oval - Red
- Search Results: trailer wiring
- Shop: Trailer Wiring
- Shop: Brake Controller
- Search Results: trailer jack
- Shop: Gooseneck Hitch
- Search Results: trailer lights
- Search Results: spare tire mount
- Search Results: brake controller
- Search Results: gooseneck hitch
