Installation Instructions for Curt T-Connector Wiring # C55369 on a 2000 Jeep Grand Cherokee

Question

Question:

adapter from car to trailer part # C55369 2000 jeep grand cherkee liminted find one for me with a pitcher to view

asked by: Frank

0

Expert Reply:

I have linked the installation instruction for you. These instructiosn have some great pictures to help you install the Curt T-Connector vehicle wiring harness, # C55369, for a 2000 Jeep Grand Cherokee. The connection point is located behind the interior trim panel in the cargo area on the driver's side.

expert reply by: Michael H

0

Answer 1

The signal wire you need to use for the left turn circuit of the #119250KIT that you referenced is a purple wire. The red is the running light circuit. On the right had side the blinker circuit is red and yellow is running lights. I attached link to…

view full answer...

Answer 2

To install the Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector #C55369 you linked to in your 2002 Jeep Grand Cherokee without factory tow package you'll need to do the follow steps: 1. Remove the rear threshold seen in…

view full answer...

Answer 3

On a 12 inch brake assembly magnet, you should be getting 3.2 to 4 max amps at 12 to 13 volts. We have an FAQ article that covers testing brakes and brake magnets that should be helpful to you. I have included a link to it. Replacing the magnet is…

view full answer...

Answer 4

The only hitches we have available for your 2004 Jeep Grand Cherokee are going to be visible below your bumper. Both the Draw-Tite #75139 and the Curt #13051. I've included an installation video of both and a picture to give you an idea of what…

view full answer...

Answer 5

Moving up a higher load range will not only increase your load capacity, but will also increase the sidewall ply strength, so you will be less likely to have a blow out. I recommend the Kenda 5.30-12 Bias Trailer Tire with 12" White Wheel - 5 on…

view full answer...

Answer 6

Hey Mark we do have a hardware kit for the 13570 Curt Trailer Hitch our item #C69VV. It is the Replacement Hardware Kit for Trailer Hitches item #RHK. This kit has the carriage bolts, square-hole spacers, serrated-flange nuts, flat washers, and…

view full answer...

Answer 7

To activate the trailer brakes you are going to need a 7-Way trailer connector since the 4-Way only has the light functions. Since you already have a 4-Way installed all you will need is #ETBC7. This will negate the need to locate that blue wire…

view full answer...

Answer 8

When you test the 4-Way on the Curt T-Connector Wiring Harness, part #56016, at the rear of your vehicle, it should show now power on all 3 pins with the lights off. If you have the vehicle head lights on, you should have around 12 volts at the brown…

view full answer...

Installation Instructions for Curt T-Connector Wiring # C55369 on a 2000 Jeep Grand Cherokee

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching