How Do I Install a Trailer Light Harness on a 2004 Jeep Grand Cherokee
Published 11/03/2008
Products Featured in This Question
Question:
how do you hook up towing lights to the stop switch on a 2004 jeep grand cherokee laredo without blowing the computer?
asked by: Al
0
Expert Reply:
To install a trailer light, you will want to use part # C55369, a Curt T-Connector that is designed to work cooperatively with the vehicle computer and wiring. It plugs into a port in the cargo area, behind a panel on the driver side. I have added a link to the instructions below.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: Curt T-Connector Vehicle Wiring Harness with 4-Pole Flat Trailer Connector
- Shop: Trailer Wiring
- Video: Curt Custom Fit Vehicle Wiring - Trailer Hitch Wiring - C55369 Review
- Q&A: Wiring New 4-Way Connector on Trailer with 5 Wires
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: Availaiblity of White Half Moon Trailer Vent
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Q&A: Why Does 4-Pin Trailer Wiring Have 5 Wires
- Article: Trailer Wiring Diagrams
- Q&A: What Size Socket Does the Dexter Dual Trailer Wheel Lug Nut with Swivel-Flange Use
- Article: Flat Towing Package for 2014-2015 GMC Terrain
- Q&A: Does The TowSmart 4-Wire Harness Have A Single Or Dual Ground Wire?
- Q&A: How To Wire LED Trailer License Plate Light For Cargo Carrier To A 4 Way Flat
- Q&A: Installing Leaf Springs on Single Axle Trailer
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: Trailer Lighting Requirements