Dimensions of the Double RV Waste Valves # T84

Question

Question:

Im looking at including this valve in my wet bay remodel. Do you have the exact dimensions of this piece?

asked by: Gordon R

0

Expert Reply:

I went out to the warehouse and measured the dimensions of the Double RV Waste Valves # T84 that you referenced.

Width - 4-1/2"
Length - 12"
Height to Closed Handle - 9-1/4"
Height to Open Handle - 12-3/4"

I have attached a photo to help illustrate those measurements.

expert reply by: Jon G

0

click to enlarge

Answer 1

The double valve you need to install on the 3-inch waste pipe in the photo is part #T84. This is the female valve designed to fit over a 3-inch pipe. To cap the 3-inch line you would need part #T50B. This is a waste valve that comes with a 3-inch…

view full answer...

Answer 2

The Valterra EZ Valve Double Electric Waste Valve #E85-8 is designed to connect to two horizontal 3-inch waste pipes to combine them for dumping through the central tube. From your photo I cannot tell if that is your setup. On this part the two…

view full answer...

Answer 3

The outlet tubes on Double RV Waste Valves #T84 are larger than those on Double RV Waste Valves #T84B. On the T84 the 3" Hubs slide OVER your RV's black-water lines. On the T84B the 3" Spigots slide INTO your RV's black-water lines.…

view full answer...

Answer 4

The Valterra Double RV Waste Valve, #T84B, has an overall measurement of 11-3/4" from edge to edge.

view full answer...

Answer 5

Hey Matthew! Thanks for providing that axle information. I reached out to Lippert and for bearings you need the Timken #TMK44FR and #TMK75FR. From what they said, your axle came with an oil bath setup so for the seal you need the Unitized Oil Seal…

view full answer...

Answer 6

The Camco Automatic Changeover 2-Stage Propane Regulator for Dual Propane Tanks #CAM59005 will allow you to use the MB Sturgis Propane Hose w/ Back Check - Type 1 x 1/4" MPT - 30" #100473-30-MBS to connect your second propane tank to the…

view full answer...

Answer 7

You are not required to use any lubrication when installing the Valterra Coupling for Rigid RV Sewer Pipe #F02-2103 that you referenced. You'd just need to slip it over the ends of the pipe and then tighten the band clamps and you'd be set!

view full answer...

Answer 8

If you're undermounting the Better Bath RV Kitchen Sink #LC421572 then you'll want to cutout hole to be between 12-7/8" and 14-1/2" deep and between 22-7/8" and 24-1/2" wide so that the lip can touch the countertop and be…

view full answer...

Answer 9

The Double RV Waste Valves #T68C and the Bristol Double RV Waste Valves #34466ND17AAR are both going to serve the same purpose. The only real difference between the two is where they are manufactured. The Bristol Double RV Waste Valves #34466ND17AAR…

view full answer...

Answer 10

That's a great question, John! Yes, you can use the etrailer Replacement Fabric #e26QV in place of the Solera Replacement Fabric #LCV000334415. They are both made to work on the same size awning, so the fabric will be the same size and will…

view full answer...

Answer 11

Hello Kevin, Thanks for writing in. The main difference between the Power Watchdog Surge Protectors #HU67FR and #HU42VR comes down to the monitoring capability, housing design, and surge protection rating. The #HU67FR is the newer Generation 2 model.…

view full answer...

Dimensions of the Double RV Waste Valves # T84

Product Page this Question was Asked From

Featured Help Information

Miscellaneous Media

Continue Researching