Will the Westin Grille Guard Interfere With Front Parking Sensors 2017 Chevy Silverado 2500

Question

Question:

I have a 2017 Chevy 2500 High Country, 4 wheel drive. It has all the sensors in the front bumper. Will this grill interfere with them, is there a kit to move them, or would you recommend a different grill. Thank you.

asked by: David H

0

Expert Reply:

Yes. the Westin Grille Guard part # 57-3785 will interfere with the front parking/obstacle detection sensors on your 2017 Chevy Silverado 2500. However, should you choose to use the guard anyway, the obstacle detection system can be disabled by removing fuse number 27 on left instrument panel fuse block. The left instrument panel fuse block access door is on the driver side edge of the instrument panel.

expert reply by: Conner L

0

Answer 1

Most aftermarket brake controllers like the excellent Prodigy units #90885 and #90195 have settings for both standard electric drum brake trailers and for electric-over-hydraulic (EOH) actuator trailers. Since these two types of trailer braking…

view full answer...

Answer 2

To determine why you do not have any power on the blue brake output wire, I recommend starting at your brake controller. First, make sure the brake controller is on and receiving power. Most brake controllers have 4 wires, blue (brake output to…

view full answer...

Answer 3

It is likely the result of a bad ground, but in order to determine the specific problem you'll need to use a circuit tester such as #PTW2993 to test the connector on your Silverado after disconnecting it from your trailer. Check the wiring going…

view full answer...

Answer 4

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

It sounds like you are speaking of the wires for the brake magnets. If this is correct, you will need to connect one of the wires to the brake controller output wire on your trailer connector and the other wire will need to be grounded to a clean…

view full answer...

Answer 7

If you just need a 4-pin to 7-pin trailer wiring adapter, then you can use part #C57672. This will plug into the 4-pin trailer connector on your brother's vehicle and give him the 7-pin socket for the trailer. Keep in mind, this will only give…

view full answer...

Answer 8

That's a very good question, we tend to be extra cautious and say to use 10 gauge wire because that would be more than enough. When you get into longer trailers that will end up using a lot of wire the heavier gauge wire becomes more necessary.…

view full answer...

Will the Westin Grille Guard Interfere With Front Parking Sensors 2017 Chevy Silverado 2500

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching