Diameter of the Mounting Holes of # SL716
Published 09/01/2017
Question:
With that said can the mounting be drilled out that extra 1/16 and not mess up the integrity of the latch?
asked by: David R
1
Helpful Expert Reply:
The mounting holes of the # SL716 are right at 1/4 inch which is 1/16 off from 5/16.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Continue Researching
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: Attaching Tow Bar to 2010 Jeep Wrangler With Rugged Ridge Bumper
- Q&A: Distance Between The Mounting Tabs On A The Roadmaster Direct-Connect Base Plate Kit # 1437-3
- Q&A: Will the Demco 5-Position Adjustable Channel Bracket Fit a Boat Trailer
- Q&A: Hardware Typically Used to Install A-Frame Trailer Jack
- Q&A: Replacement Brake Assemblies for Dexter 023-358-00 Trailer Brakes
- Q&A: Available Replacement Parts for Tie Down Engineering LP7000 Actuator
- Q&A: Tie Down LP7000 Brake Actuator Replacement
- Article: Trailer Lighting Requirements
- Article: Rooftop Cargo Carriers
- Article: Slipper Spring Trailer Suspension System Review
- Article: How to Raise Your Travel Trailer Height
- Article: How to Accurately Measure Trailer Leaf Springs
- Article: Adding Electric Over Hydraulic Disc Brakes
David
9/1/2017
With that said can the mounting be drilled out that extra 1/16 and not mess up the integrity of the latch?