Taller Single Axle Hanger Kit Recommendation for Use with Trailer Leaf Spring # e59SR
Question:
looking for a hanger kit for single axle trailer for item # e59SR was wanting a taller one so trailer be a little higher off ground- also are spring center pins usually the same on all axles i have a older axle i am using but wanted new springs
asked by: James
Expert Reply:
The tallest single axle hanger kit we offer is the # APS4. It comes with front hangers that are 3-1/4 inches tall and rear ones that are 1-1/4 inches tall. This is a couple inches taller than the other kits we offer.
Most leaf spring bolts are the same size on single axle trailers. Normally they are all 9/16 inch in diameter.
Products Referenced in This Question
Single-Axle Trailer Hanger Kit for Double-Eye Springs - 3-1/4" Front, 1-1/4" Rear
- Trailer Leaf Spring Suspension
- Hangers
- Suspension Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Double Eye Springs
- Single Axle
- etrailer
more information >
Product Page this Question was Asked From
3-Leaf Double-Eye Spring for 3,500-lb Trailer Axles - 23-1/8" Long
- Trailer Leaf Springs
- Double Eye Springs
- 3500 lbs
- 1-3/4 Inch Wide
- 3 Leaf
- 23-1/8 Inch Long
- Painted
- etrailer
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Shop: 3-Leaf Double-Eye Spring for 3,500-lb Trailer Axles - 23-1/8" Long
- Shop: U-Bolt Plate - 2-3/8" Diameter, Round Trailer Axle - 1-3/4" Wide Spring - 1/2" Bolts
- Shop: U-Bolt Plate - 3" Diameter, Round Trailer Axle - 1-3/4" Wide Spring - 1/2" Bolts
- Shop: U-Bolt Plate - 1-3/4" Diameter Trailer Axle - 1-3/4" Wide Spring - 3/8" Bolts
- Video: Review of etrailer 4 Leaf Slipper Spring - e89SR
- Shop: Single-Axle Trailer Hanger Kit for Double-Eye Springs - 3-1/4" Front, 7/8" Rear
- Search Results: 3020
- Search Results: 30~20
- Shop: 3-Leaf Double-Eye Spring for 4,000-lb Trailer Axles - 25-1/4" Long
- Video: Dexter Trailer Springs Over-Under Conversion Kit Installation K71-384-00
- Shop: U-Bolt Plate for 3" Diameter Axle, 1-3/4" Wide Spring - 1/2" Bolts - Galvanized
- Q&A: Hanger Kit to Use with Leaf Spring # SP-216275
- Q&A: Installing Leaf Springs on Single Axle Trailer
- Article: Where to Position the Trailer Axle?
- Shop: Suspension Enhancement
- Q&A: How to Determine Weight Capacity of Trailer Axle
- Q&A: Should Hitch Ball Angle Be Adjusted Up and Down or Angled to the Rear Using Weight Distribution
- Q&A: Can a Trailer with a Straight Tongue Use a Weight Distribution System
- Q&A: How to Determine GAWR of 2-1/2-Inch Square Axle By Using Bearing Numbers
- Q&A: Recommended Hanger Spacing for Triple Axle Trailer
- Search Results: spindle
- Search Results: ap233
- Search Results: sp~216275
- Search Results: tounge jack
- Video: Hopkins Trailer Breakaway Kit Battery Charger Installation
- Search Results: spindles
- Shop: Exhaust