Pick Out Powered Landing Gear for 2008 Fuzion 393 Toyhauler

Updated 07/11/2017 | Published 07/10/2017

Products Featured in This Question

Ultra-Fab Deluxe Electric Landing Gear Set - Weld On - 38" Lift - 12,000 lbs

(281)

$1127.98

Question:

Need to replace the landing gear on our 2008 Fuzion 393 Toyhauler. Dry weight on 5th wheel is 13,140lbs - its a heavy trailer. Current system is single motor electric and has failed more than once - looking to replace with dual motor heavy duty landing gear. Also from looks of things I will have to remove the generator to get to one side of landing gear. Which system would best fit our needs and trailer: Bulldog or the Ultra Fab UF17-943010.

asked by: Denise B

Helpful Expert Reply:

In order to pick out a direct replacement for the landing gear on your 2008 Fuzion 393 we would need to know the distance between the mounting brackets. Otherwise you could just have the brackets removed from your trailer by a qualified welder and then install the brackets that come with the Reese/Bulldog Tandem Landing Gear Set # RP500708. Either way this landing gear set would work well for you, you just might have to have the brackets of your trailer removed.

I attached a picture that shows the dimensions that this landing gear set would fit with.

The jacks would be the correct replacement for Lippert, Venture, and Atwood landing gear, as well as those from a few other manufacturers. The sure way to tell is that if the distance between the mounting brackets (underside of top bracket to top of lower bracket as shown in the diagram) is 17-1/2 inches. If this is the case, the landing gear should fit just fine.

If your frame clamps are instead 20-1/4 inches the Ultra Fab part # UF17-943010 would be a direct replacement.

expert reply by: Jameson C