Does Trailer Light STL101RB Require Rubber Grommet to Install with A45SB
Updated 07/05/2017 | Published 07/03/2017
Question:
Im thinking of updating my trailer to LED lights. Do the lights STL101RB need a rubber grommet to attach to the Mounting Flange A45SB? Thanks!
asked by: John V
1
Helpful Expert Reply:
You do not need to use a rubber grommet for the # STL101RB to install using the mounting flange part # A45SB which you also referenced. Those two parts together would be all that you need.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
GloLight Halo LED Trailer Light - Brake, Turn, Tail - Submersible - Round - Red
- Trailer Lights
- Tail Lights
- Stop
- Tail
- Turn
- Round
- Recessed Mount
- Submersible Lights
- LED Light
- 4-5/16 Inch Diameter
- Red
- Optronics
more information >
Continue Researching
- Q&A: Replacement Motor for Kwikee Motor Assembly 214-1009
- Q&A: Replacement Motor 1101422 / 214-1001 and Gear Box for Kwikee Electric RV Steps
- Article: Most Popular Wheel Bearings
- Q&A: Will Curt Trailer Hitch Receiver Fit 2005 Honda Civic EX Special Edition Coupe
- Q&A: Replacement 5th Wheel LED Tail Light for a Round Red Light
- Q&A: Keyed Alike 1-1/8 Lock Cylinders for Baggage Doors and Shower
- Q&A: RV Compartment Lock
- Q&A: Flange to Flange Measurement on RV Slide Out For Slide Topper Awning Fit
- Article: 5 Reasons to Convert Your RV Lights to LEDs Today
- Article: Trailer Wiring Diagrams
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Trailer Lighting Requirements
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)