Is Vehicle Frame Modification Needed for Installing Curt Hitch part # C13190
Published 06/30/2017
Question:
The Curt Sequent Performance Products 76024 required cutting the steel bumper beam. I sent your technical department extensive color photo documentation of this process on 2 vehicles that I did. Question: Is this new part number C13190 redesigned? Sincerely,
asked by: David G
0
Expert Reply:
I attached a link to the install instructions for the Curt hitch part # C13190 that you referenced. There is not frame drilling or modification but there is some heat shield modification required.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 900 lbs TW
- 7500 lbs GTW
- 2 Inch Hitch
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Trailer Hitch Receiver Fit For 2016 Mercedes-Benz GL450 4MATIC
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Identifying Tail Light Wires On 2017 Mercedes GLS 450 When Installing a 4-Way Trailer Wiring Harness
- Q&A: Is There a Plug In Adapter for a Brake Controller for a 2024 Ford Ranger
- Q&A: Why Is it Better to Have Trailer Wiring that Stores Inside 2015 Mercedes GL550
- Q&A: Replacement Equalizers for Dexter 13-143 Equalizers
- Article: RV-Mounted vs Vehicle-Mounted Tow Bars
- Q&A: Trailer Hitch Needed for a 2013/2014 Mercedes-Benz GL450
- Q&A: Can I put Truck Wheels on My Trailer
- Article: How to Measure for Trailer Hitch Drop
- Article: Trailer Wiring Diagrams
- Article: How to Wire an Electric Winch