Mounting Hole Dimension on Pacer Performance Hi-Five Truck Cab Lights # PP20-105

Updated 06/06/2017 | Published 06/04/2017

Question:

I am looking to replace some vintage VP 63 SAEs rather than have to covers rechromed, but I dont want cut additional holes in the roof. What is the distance between the front and back mounting holes? My VPs also are slightly curved to match the front of the 54 Ford F100 cab, but you dont have a side view picture to show if there is a curve to this light. Would this be a suitable replacement to the VP 63?

asked by: Glenn M

Expert Reply:

I went out to the warehouse to take a look at the Pacer Performance Hi-Five Truck Cab Lights # PP20-105 referenced in your question.

I measured the distance between the two mounting holes to be 6-1/2 inches center to center. The underside of the light does have a very slight curve and features a flexible rubber padding that should be able to adjust to the contours of your 1954 Ford F-100 cab.

I have also attached the installation details on this product for you to check out so you can see exactly how these will mount to the vehicle.

expert reply by: Chris R