Tru Flate Wall Mounted Tire Inflator Compatibility With Wall Mounted Air Compressor Hose
Updated 05/23/2017 | Published 05/21/2017 >
Question:
Regarding the tru flate wall mounted tire inflator. If I wanted to use this with a wall mounted air compressor hose, will it thread directly or is there a separate connector I can purchase to do it?
asked by: Kevin N
Expert Reply:
The Tru-Flate Wall-Mounted Tire Inflator - 110 psi - 120 Volts # 16-250 has a standard tire valve size fitting coming out the bottom where the coil hose attaches. The other end of the hose has a 1/4 inch male NTP fitting and then the valve assembly. If your wall mounted air compressor hose fits either of these fittings, then you can absolutely use it.
Product Page this Question was Asked From
Tru-Flate Wall-Mounted Tire Inflator - 110 psi - 120 Volts
- Tire Inflator
- Tire Inflator
- Wall-Mount
- 110 psi
- 120V
- Digital Pressure Gauge
- Manual Shut Off
- Tru-Flate
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Pros and Cons of Running Two Inflation Valves or One in Air Bag Suspension Kit on Vehicle
- Q&A: Recommended Suspension Support While Towing a Trailer w/a 2023 Chevy Colorado ZR2
- Q&A: How To Adjust The Roadmaster Exact Center Steering Stabilizer For A More Comfortable Ride
- Q&A: Do I Need a Sliding 5th Wheel Hitch for a 2024 Chevrolet Silverado 2500 w/ a 6-3/4 Foot Bed?
- Q&A: Dimensions of Mounting Brackets of Buyers Products Forged D-Ring
- Q&A: What is the Capacity of Buyers Products 5/8 Forged D-Ring 337B40MP
- Q&A: Size and Grade of Hardware Included with Buyer's Products 5/8 Inch Forged D-Ring Tie-Down 337B40MP



