Mounting Bracket for Tekonsha BRAKE-EVN and Wiring Harness for a 2016 Honda Pilot
Updated 05/11/2017 | Published 05/10/2017
Products Featured in This Question
Question:
We have two vehicles capable of towing our RV. One is a Chrysler TownandCountry, which is currently set up with the I-Command controller and the other is a 2016 Honda Pilot which has all the wiring at the back of the vehicle for the 7-wire connector but does not have the controller installed. I need a 2nd controller mounting bracket for the Honda Pilot and a wire that plugs into our I-Command controller and also into the factory Honda Pilot connector for trailer brakes under the dash. This wire needs to be about 1-1/2 to 2 feet long. Can you help me with this?
asked by: David P
Expert Reply:
The Tekonsha BRAKE-EVN # TK63VR uses mounting bracket # 20059. For the wiring harness that will fit your 2016 Honda Pilot use # 3070-P which is about 18 inches long so it is within the length you are wanting.
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Q&A: What Towing Mirrors are Best for My 2008 Toyota FJ Cruiser, Should I Off-Road with them On?
- Q&A: How to Bypass the Factory Brake Controller w/a Bad Module on a 2014 Chevy Silverado 2500
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: Aftermarket Brake Control Wiring for 07-13 GM Full-Size Truck with Factory-Integrated Brake Control
- Q&A: Installing a 7-way Trailer Connector on a 2018 Subaru Outback
- Q&A: Looking For A Brake Controller For My 2019 Nissan Frontier
- Q&A: What Does ER Code of Reese Brake Controller Indicate
- Q&A: Converting Shorelandr Boat Trailer from Slipper Spring to Double Eye