Base Dimensions and Mounting Hole Spacing for Quick Fist Super Clamp # QF20020
Updated 05/03/2017 | Published 05/01/2017
Question:
What are the outside dimensions length and width and hole spacing on the base of this large Quick fist holder? Looking forward to hearing back from you. Thank you so much for your time.
asked by: Bernard P
0
Expert Reply:
The base on the Quick Fist Super Clamp # QF20020 is 6 inches long and 7/8 inches wide. There are 3 mounting holes. From the first to the middle it is 2-3/4 inches on center and the same from the middle to the last.
expert reply by:
Michael H
0
click to enlarge
Product Page this Question was Asked From
Quick Fist Super Clamp - 2-1/2" to 9-1/2" Inner Diameter - Rubber - 50 lbs
- Tie Down Straps
- Trailer
- Tie Down Clamp
- 0 - 175 lbs
- Quick Fist
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: What Size Pipe Does Rhino-Rack Conduit Endcaps # RR92SV Fit
- Q&A: Replacement Propane Gas Detector for an Atwood 31013 Propane Detector
- Q&A: How Far from the Mounting Bracket is the Bottom of the etrailer Manual Sidewind Trailer Jack?
- Q&A: Can Roadmaster Dual Hitch Receiver Adapter be Used to Flat Tow & Carry Bikes/Kayaks
- Q&A: Is There Ball Mount Adapter that Allows for Towing Trailer and Carrying Bike Rack
- Q&A: Comparing Roadmaster Dual Hitch Receiver Adapters RM23SR And RM-077-10
- Q&A: Do All A-Frame Trailer jacks have the Same Mounting Hole Pattern
- Article: How to Measure for Trailer Hitch Drop
- Article: What are the Common Types of Propane Fittings Used on RVs?