Direction Rear Hanger # 30-66-1 Should Face
Updated 03/14/2017 | Published 03/13/2017
Question:
Which way does the hanger face? Does the plate inside the hanger, face the front of the trailer towards the equalizer and the I/2inch bolt hole face the rear of the trailer? Thanks
asked by: Bill
1
Helpful Expert Reply:
You are correct. The angle of the plate in the Rear Hanger # HAP-103-00 you referenced faces forward and the bolt hole points towards the rear of the trailer.
expert reply by:
Jameson C
1
Product Page this Question was Asked From
Dexter Single-Axle Trailer Hanger Kit for 3" Slipper Springs - 6-1/4" Front
- Trailer Suspension Parts
- Hangers
- Suspension Kits
- Boat Trailer
- Camper
- Car Hauler
- Snowmobile Trailer
- Utility Trailer
- Slipper Springs - 3 Inch
- Single Axle
- Dexter
more information >
Continue Researching
- Q&A: Recommended Trailer Axle for 6 Foot Wide Trailer
- Article: Most Popular Wheel Bearings
- Q&A: Parts to Convert 5-Spoke Utility Hub to Modern Style Hub on 10K Trailer
- Article: Trailer Wiring Diagrams
- Q&A: What is the Replacement Hose for a h72812-108 Flex Tech Hose?
- Q&A: Troubleshooting Brakes Sticking With Dexter DX Series Electric Over Hydraulic Actuator K71-650
- Q&A: Replacement Motor and Fan Blade For Ventline V2094 Exhaust System
- Q&A: Electric Lockout Solenoid Needed For A Dexter DX6.6 Disc Brake Actuator
- Q&A: Difference Between 30205 and L44643 Bearings
- Article: Trailer Tire Sizing
- Article: How to Raise Your Travel Trailer Height
- Article: Slipper Spring Trailer Suspension System Review
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Keep Your Daydream