Distance from Center of Hitch Pin Hole to Start of Hook on MaxxTow Tow Hook # MT70028
Updated 03/07/2017 | Published 03/06/2017
Question:
How far is the center of the pin hole from the back of the hook face plate?
asked by: John Y
0
Expert Reply:
I went out to the warehouse to take that measurement on the MaxxTow Tow Hook # MT70028 for you. From the center of the pin hole to plate where the hook starts to come out is 4-1/8 inches. To the back of that plate it is approximately 1/4 inch less so 3-5/8 inches.
expert reply by:
Michael H
0
click to enlarge
Product Page this Question was Asked From
MaxxTow Tow Hook for 2" Trailer Hitches - 10,000 lbs
- Tow Hooks
- Standard Tow Hook
- Receiver Mount Hook
- 10000 lbs GTW
- Solid Shank
- Fits 2 Inch Hitch
- Steel
- Black
- MaxxTow
more information >
Continue Researching
- Article: 7 Common Questions Everyone Has About Trailer Tires
- Q&A: Does Grease Seal of Easy Grease Trailer Hub and Drum Prevent Grease from Getting on Brakes
- Q&A: Replacement Trailer Hub Assemblies For 3,500LB Axles Using L68149 Inner and L44649 Outer Bearings
- Q&A: Does the Dexter Trailer Hub and Drum Assembly # 84546UC3 Come Fully Assembled
- Q&A: Hub and Drum for Dexter Trailer Axle Beam with E-Z Lube Spindles
- Q&A: Can the Rain Sensor on a MaxxAir Vent be Overridden
- Q&A: Comparing The etrailer # e98902 and Curt # C13315 Trailer Hitches For A 2022 Mazda CX5
- Q&A: Why Does My Brake Controller Light Stay On After Vehicle is Turned Off
- Article: 5 Things to Know About Weight Distribution Hitches
- Article: Rooftop Cargo Carriers
- Article: Performance Chips and Modules