Mounting Hole Spacing of Pro Series A-Frame Trailer Jack
Updated 02/28/2017 | Published 02/27/2017
Products Featured in This Question
Question:
What is the mounting hole pattern center to center dimension for this jack? Im sure these are all standard, but I want to make sure. This would be a good spec. to include in the description.
asked by: Matt
0
Expert Reply:
The mounting holes of the Pro Series A-Frame Trailer Jack # PS1400600303 is 3 inches center on center. And you're correct this is an industry standard.
The matching foot plate is # PS1400700340 and the caster is # PS1400750340.
expert reply by:
Charles S
0
Product Page this Question was Asked From
Pro Series Round, A-Frame Jack - Topwind - 15" Lift - 5,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- A-Frame Jacks
- Standard Grade
- 4001 - 5000 lbs
- Manual Jack
- 15 Inch Lift
- Bolt-On
- Weld-On
- No Wheel or Foot
- Pro Series
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Can Tradesman Hydraulic A-Frame Trailer Jack Fit on Enclosed Trailer in Place of Fulton Jack
- Q&A: Are Spacers Needed for Timbrens on 2021 Chevrolet Silverado 1500 Z71 Trail Boss
- Q&A: Comparing SumoSprings and Timbrens for a 2021 GMC Sierra 1500 AT4
- Q&A: Will The Timbren Suspension Enhancement Fit a 2024 Chevrolet Silverado 1500 ZR2?
- Q&A: Which Timbren Kit for 2024 GMC Sierra 1500
- Q&A: What is the Best Way to Jack Up a Boat Trailer with Torsion Axles
- Q&A: Will The Air Lift 1000 Heavy Duty Air Helper Springs Survive Sub Zero Temps on 2012 Ram 1500?
- Article: Best 2020 1/2-Ton Trucks for Towing a 5th Wheel
- Article: Trailer Wiring Diagrams
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)