Will Yakima Replacement Mounting Bracket Kit Y8860048 Fit 2007 Cadillac Escalade Factory Roof Bars
Updated 01/17/2011 | Published 01/15/2011
Question:
Would the Y8860048 bracket work on a factory crossbar for a 2007 Cadillac Escalade? The bracket is approx. 2 across and about 3/4 thick at its thickest area. Or would one of V series V1 thru V29 be a better fit?
asked by: Jack K
Expert Reply:
The # Y8860048 replacement mounting bracket should fit well on the factory cross bars on your 2007 Cadillac Escalade. This hardware and bracket kit is a replacement piece for the Yakima FatCat roof-mounted ski and snowboard carriers which will fit cross bars up to 3-7/8 inches wide or 1-1/4 inches tall.
Although the mounting brackets will fit your factory cross bars, I recommend confirming the model of your Yakima ski rack to make sure the # Y8860048 kit is the correct match. The replacement brackets are intended for specific models, and are not interchangeable.
Product Page this Question was Asked From
Replacement Mounting Hardware for Yakima FatCat Ski and Snowboard Carrier
- Accessories and Parts
- Ski and Snowboard Racks
- Hardware
- FatCat
- Yakima
more information >
Continue Researching
- Q&A: What Plastic Screw Nuts Go With The 7533998 Mounting Kit?
- Q&A: What is the Difference Between the Mighty Mount 39H and 23H Accessory Adapters
- Q&A: Can You Secure Old Yakima Round Bar Accessories with T-Bolts to Yakima JetStream Crossbars
- Q&A: What Type of Roof Rack Does Thule Flat Top Ski Rack Fit
- Q&A: Replacement Mounting Hardware for Older Model Yakima FatCat 6 Ski Carrier
- Q&A: Can LockRack Hardware Kayak Carrier Hardware be Swapped to T-Bolt
- Q&A: How To Mount Old Thule Square Bar Ski Carrier On New Factory Aero Bars
- Article: Wiring Trailer Lights with a 5-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How Much Does a Boat and Trailer Weigh?