Can A Hole Be Cut In The Spare Tire Cover To Accommodate A Bike Rack Mount?
Updated 02/08/2017 | Published 02/07/2017
Question:
Can a hole be cut in this fabric to accommodate a Spare Tire bike rack?
asked by: Susan A
Expert Reply:
Yes. The Camco Vinyl Spare Tire Cover - 27" Diameter - Colonial White # CAM45346 can have a hole cut in it to allow for a spare tire bike rack. This cover is vinyl so it will allow you to make a clean cut in the center and allow you the protection of the cover for the tire itself. My recommendation would be to use the bike rack mount to locate the area needed to be removed and remove only that section so you can protect the tire and wheel as well as have a clean look.
If you want to prevent fraying, you might want to sew the edges or use a large grommet like they use on shower curtains and tarps.
Product Page this Question was Asked From
Camco Vinyl Spare Tire Cover - 27" Diameter - Arctic White
- Spare Tire Covers
- 27 Inch
- Vinyl
- White
- Camco
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Recommended Tire Covers for 205/75-15 Size Tires
- Q&A: Spare Tire Cover Recommendation for Tire Size 205/75-14
- Q&A: Comparing Kenda KR03, KR35, And KR53 Tires
- Q&A: Longer Weight Distribution Shanks
- Q&A: Troubleshooting Curt Hitch # C13098 Not Being Wide Enough to Fit Over Brackets of Vehicle
- Q&A: Weight Distribution System For 6200 Pound Winnebago With 700 Pound Tongue Weight
- Q&A: Replacement Stabilizer Jack for 2021 Jayco Jay Flight SLX 7 174BH
- Article: Replacing the Bearing, Races and Seals on a Trailer Hub
- Article: 2 Steps for Hooking Up an External Propane Tank to Your RV
- Article: What are the Common Types of Propane Fittings Used on RVs?
- Article: RV Propane 101: How Does My RV's Propane System Work?