Swivel Bracket Availability for Roller Bunks to Allow Matching of Roller Bunk Angle to Hull Angle
Published 01/04/2017
Products Featured in This Question
Question:
I plan to use roller bunks on a ramp on a lake to launch and retrieve/temporarily store a PWC. I would like to angle the bunks 45 degrees so more of the wheels are on the hull. Is there a bracket designed for this? The ramp is wood and goes down to around a half a foot below the water line.
asked by: David S
Expert Reply:
The swivel bracket part # CE10000G is exactly what you are looking for. The top of the bracket can swivel to either side to allow the roller bunks to be angled to match your hull.
For a 5 foot long roller bunk we have the part # DL21741 which would be a great option.
Product Page this Question was Asked From
Yates Endcap for Boat Trailer Rollers - TPR - 1/2" Shaft - Qty 1
- Boat Trailer Parts
- Rollers
- End Cap
- 1 Inch Wide
- 2-3/4 Inch Diameter
- Plastic
- Fits 1/2 Inch Shaft
- Yates Rubber
more information >
Continue Researching
- Q&A: Installation Instructions For The Progressive Dynamics Pure Sine Wave Inverter w/ Transfer Switch
- Q&A: Replacement 6" x 2" Roller for Older Boat Trailer
- Q&A: How To Measure For Replacement Overhead Springs On A Trailer Door
- Q&A: What Are the Differences Between Yellow, Blue and Black Boat Rollers
- Q&A: Replacing Bow Strap and Winch Mount on on Older Shoreline Sailboat Trailer
- Q&A: Bow Roller Recommendation to Fit 4 inch Roller that is Too Long
- Q&A: Solution for a 5 inch Bow Roller Assembly