Will Demco Hydraulic Drum Brake Assembly Fit Trailer Axle with 10 inch Hub/Drums
Updated 10/31/2016 | Published 10/30/2016
Question:
will the brake flange I bought with a 10inch ez grease hub bolt on the axel using the existing flange or will I have to take the old flange off and weld on a new one? my spindle is undamaged and the bearings and seals fit right on the axel end. I have a 1985 ranger trail boat trailer with a 2x2 axel.
asked by: Don K
Expert Reply:
As long as you match up the bolt pattern of the brake assembly you have to the mounting flange of your trailer they will bolt right up. This is typically very easy since nearly all axles use the same 4 and 5 bolt mounting flanges.
If your mounting flange has a 4 bolt pattern the part # 18788 that you referenced would bolt right up.
Product Page this Question was Asked From
Demco Hydraulic Drum Brake Assembly - Single Servo - Galvanized - 10" - Left Hand - 3,500 lbs
- Accessories and Parts
- Trailer Brakes
- Hydraulic Drum Brakes
- LH
- 3500 lbs
- Brake Assembly
- Single Servo
- 10 x 2-1/4 Inch Drum
- Demco
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Trailer Wiring Diagrams
- Q&A: Do Curt Single Hook Coiled Safety Cables Meet Legal Requirements for Towing
- Q&A: Finding a Hub for a Very Old Trailer with 6 Lug Bolt Pattern # 1779 inner and # 2788 Outer Bearings
- Q&A: Replacement Wheel Studs for Hub 22834
- Q&A: Availability of Grease Seal Ring for Seal on 22834 Trailer Hub
- Q&A: Replacement Wheel Cylinders for Demco Kar Kaddy KK360SS
- Q&A: Difference Between Demco 10 inch Drum Hydraulic Brakes and etrailer.com Brand Brakes
- Q&A: Replacement for UFP HD1377 Trailer Hub/Drum
- Article: Double-Eye Trailer Suspension System Review