Sway Bar and Steering Stabilizer Recommendation for 2017 Thor Ace 30.2 F-53 Chassis
Published 10/11/2016 >
Products Featured in This Question
Question:
Hi, Just recently purchased a 2017 Thor Ace 30.2, on a F-53 chassis. I was interested on your sway bar RM-RBK9-RSSA and wanted to know if it will fit and if it will help on handling. Also, I wanted to tow a small car Fiat 500 and was looking for towing packages tow bar, brakes, lights etc.. Please inform what products to look at the RV can tow up to 8,000lbs, but the FIAT is no more than 3,000lbs. Looking forward to your advice. Thank you,
asked by: Genti C
Helpful Expert Reply:
For your 2017 Thor Ace that is built on a 2016 Ford F-53 chassis rear sway bar upgrades are a great way to make a notoriously difficult to drive vehicle much easier to drive. For that you would want the # RM-1139-143 this will give you the biggest improvement in overall handling. A steering stabilizer like what you referenced # RM-RBK9-RSSA will help as well but we recommend typically to start with the rear sway bar.
I would need to know what year/make/model of vehicle you plan to flat tow, to pick out the base plate kit but I can help you pick out everything else right now.
One of the best tow bars is the Blue Ox Avail part # BX7420 as it is easiest to connect/disconnect and comes with safety cables.
For lighting you can use the diode kit, # RM-15267, and not have to worry about cutting into the taillight housing. This will splice into your taillight wiring to allow your tow vehicle to control the taillight assemblies of the towed vehicle. This comes with a round 6-way connector that you will install on the front of your towed vehicle and enough coiled wire to go from there to the RV.
And finally, most states now require supplemental braking in the vehicle being flat towed. The easiest system to set up and use is the Blue Ox Patriot # BLU37TR, that applies the vehicle brakes in proportion to how much the tow vehicle is braking. This is the safest way to stop and it reduces wear and tear on both vehicles.
Most likely you will also need a high low adapter so that the tow bar will be level when you are flat towing. I attached a link to a page that has all of the ones we carry.
I have included a couple of helpful links to our articles on flat towing for you. Be sure to consult the vehicle owners manual for more specific information on flat towing your vehicle.
Product Page this Question was Asked From
Roadmaster Rear Anti-Sway Bar - 1-1/2" Diameter
- Anti-Sway Bars
- Anti-Sway Bar
- Rear
- 1-1/2 Inch Diameter
- Fixed End Link
- No Drilling Required
- Mounting Hardware Included
- Roadmaster
more information >
Featured Help Information
Instructions
Miscellaneous Media
Continue Researching
- Q&A: Installing Extended U-bolts for Roadmaster Rear Anti-Sway Bar 1139-143 on 2004 F-53 Chassis
- Q&A: Recommended Anti-Sway Bar, Steering Stabilizer, and Air Bags for 2018 Thor ACE 30.3
- Q&A: Suggested Installation Time On Roadmaster Rear Anti-Sway Bar # RM-1139-143
- Article: Flat Towing Package for 2025 Chevy Trailblazer
- Q&A: Front and Rear Sway Bar Recommendations for a 2018 Forest River FR3 30DS with an F-53 Chassis
- Q&A: Choosing Front or Rear Anti-Sway Bar for 2013 Thor ACE 30.1
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Q&A: Do Front Anti-Sway Bar and TruTrac System Install at Same Locations on 2007 Workhorse W-22 Chassis
- Q&A: Do Tabs Stay on etrailer Invisible Base Plates For 2022 Jeep Wrangler When Using etrailer SD Tow Bar
- Article: How to Measure a Trailer Axle
- Article: Which RV Propane Tank Size Do I Need?
- Article: Trailer Wiring Diagrams
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: The 5 Best Trailer Drop Hitches You Can Buy


