9/16 Inch Diameter Pull Pin for a Pro Series Pipe Mount Swivel Jack
Updated 10/05/2016 | Published 10/04/2016
Products Featured in This Question
Question:
I need a replacement 9/16inch diameter pin for Pro Series Round, Pipe-Mount Swivel Jack, # PS1401460303. I cant find it on your web site. Is it available separately? Thank you.
asked by: Mark
1
Helpful Expert Reply:
For a 9/16 inch diameter pull pin you can use with your Pro Series jack use # BD500243. It also has the chain and a bolt to attach the chain if needed. The useable pin length is 2-1/2 inches and the overall length is 3-1/2 inches.
expert reply by:
Michael H
1
Product Page this Question was Asked From
Pro Series Round, Pipe-Mount Swivel Jack w/ Footplate - Topwind - 10" Lift - 5,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Side-Mount Jacks
- Swivel Jacks
- Standard Grade
- 4001 - 5000 lbs
- Manual Jack
- 10 Inch Lift
- Weld-On
- With Rectangle Foot
- Pro Series
more information >
Continue Researching
- Q&A: How Can I Get Replacement Parts For B&W Companion 5th Wheel Hitch?
- Q&A: Recommended Replacement Wheel Stud For a 2016 Kaufman 3 Car Wedge Trailer With 7,000 lb Axle
- Q&A: Replacement Hardware For B&W Companion Hitch
- Q&A: Is Advent Air Low Profile RV AC Plug and Play
- Q&A: Is Furrion Vision S+ Direct Replacement for Vision S
- Q&A: 2k Trailer Jack Recommendation that Fits 2 inch Pipe Mount and has 15 inches of Lift
- Q&A: Can Straight and Cambered Axle be Used on Tandem Axle Trailer
- Article: Trailer Couplers
- Article: Determining Trailer Tongue Weight
- Article: How to Measure for Trailer Hitch Drop
- Article: How to Mount a Truck Bed Camper
- Article: Trailer Lighting Requirements
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: Where to Position the Trailer Axle?