Are Holes in Lid Of TorkLift Battery Box Designed For Ventilation
Updated 08/15/2016 | Published 08/12/2016
Question:
Howdy, I recently purchased the lockable battery box to hold my two 6V batteries. There are small plastic hole plus in the sliding top. I noticed a couple were missing. Should I be concerned about moisture getting in or are they there for ventilation? If so, I assume the box is not really waterproof or intended to be. Any advice would be helpful, thanks.
asked by: Eric M
Expert Reply:
The holes in the sliding lid on a TorkLift battery Box like part # TLA7708R are designed to let you run wiring and also designed for ventilation as you mentioned. These battery boxes are not waterproof.
I confirmed this with my contact at TorkLift.
Product Page this Question was Asked From
TorkLift PowerArmor Locking Battery Box - 6V and 12V Batteries - Diamond Plate Aluminum
- Battery Boxes
- Camper Battery Box
- Trailer Battery Box
- 12V
- 6V
- 2 Batteries
- Lockable
- Aluminum
- TorkLift
more information >
Continue Researching
- Q&A: Battery Box Recommendation for Holding two Group 27 Trailer Batteries
- Q&A: How to Mount 2 Batteries on A-Frame Trailer with Limited Space on Tongue
- Article: Trailer Wiring Diagrams
- Q&A: Installation Methods for TorkLift PowerArmor Locking Battery Box
- Q&A: Battery Box for 2 Group 27 Batteries
- Q&A: Can Two 13" Long Batteries Fit Inside TorkLift PowerArmor Locking Battery Box
- Q&A: Battery Box that Can Fit Two Batteries that are 12.5 inch Long, 9 inches Tall, and 6-3/4 inches Wide
- Q&A: Will Two Battle Born Batteries Fit In The TorkLift TLA7700L Battery Box
- Article: Determining Trailer Tongue Weight
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Holiday 2025 | RVers’ Favorite Gear & Road Picks
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: How to Change a Trailer Tire