Availability of 8 inch Extensions for Ultra Fab Tripod Fifth Wheel Stabilizer
Published 08/03/2016
Products Featured in This Question
Question:
Have an Anderson hitch on 5th wheel and have the tripod but front of trailer sits too high to get good stability. Do you carry part #19-950202 the 8inch extensions for the legs? Thank you.
asked by: Karen C
0
Expert Reply:
Yes we do carry the # UF19-950202 that you referenced. These are 8 inch extensions for the Ultra Fab tripod stabilizers that are aluminum. If you have the steel stabilizer then use extensions # UF19-950002.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Ultra-Fab Gooseneck Trailer Tripod Stabilizer - Steel - 31" to 54" - 5,000 lbs
- Camper Jacks
- 5th Wheel Camper
- Tripod Jacks
- Steel
- 4001 - 5000 lbs
- Manual Jack
- 1 Jack
- Ultra-Fab Products
more information >
Continue Researching
- Q&A: Gooseneck Tripod Trailer Stabilizer Recommendation with Height that is at Least 58 inches
- Q&A: Tripod Stabilizer That Works With The Andersen Ultimate 5th Wheel Ssytem
- Q&A: Does Lippert Electric Landing Gear LC333964 Fit 2011 Laredo 266rl 5th Wheel?
- Q&A: Will The Weigh Safe Flap Jacks Be Able To Support My Truck Bed Camper?
- Article: Holiday 2025 | RVers’ Favorite Gear & Road Picks
- Q&A: Replacement Bearings For A 6,000 Pound Dexter Axle
- Q&A: Looking For A Replacement Ladder For My 2019 Jayco Greyhawk 26y
- Q&A: Spare Wheel and Tire Carrier Recommendation for Jayco Redhawk Class C Motorhome
- Article: How to Dump Black and Gray RV Waste Tanks
- Article: How to Tell the Weight Rating of a Trailer Axle
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: 4 Steps to Choosing Your 5th Wheel Pin Box
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps