Where Does Red Wire of Curt Trailer Wiring Harness # C59236 Wire
Published 08/01/2016
Products Featured in This Question
Question:
Followed the video instructions on youtube and turn signals work but not the brake lights. Can you confirm the correct wire for the red line to be spliced into?
asked by: Al
0
Expert Reply:
The red wire of the # C59236 would need to run to the stoplight circuit of your vehicle if it has separate turn and brake lights. Or if they are combined on the same circuit it would just get grounded.
You may need a circuit tester like the part # PTW2993 to find the stop light circuit.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Curt Powered Tail Light Converter with 4-Pole Flat Trailer Connector
- Custom Fit Vehicle Wiring
- Trailer Hitch Wiring
- Vehicle End Connector
- Powered Converter
- Universal Fit
- 4 Flat
- Plug and Lead
- Splice-In
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Trailer Wiring Diagrams
- Q&A: What is the Difference Between a Class II and a Class III Hitch?
- Q&A: Recommended Hitch and Trailer Wiring for a 2026 Toyota RAV4 Hybrid
- Q&A: What is the Difference Between a 4-Way and 7-Way Trailer Connector
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Wiring Trailer Lights with a 4-Way Plug (It's Easier Than You Think)
- Article: How to Choose the Right Trailer Hitch Class
- Article: How to Measure for Trailer Hitch Drop
- Article: My Trailer Hitch Doesn't Fit
- Q&A: Trailer Hitch and Wiring for 2027 Kia Telluride
- Q&A: Is There a Trailer Hitch that Fits 2026 Toyota RAV4 Hybrid
- Q&A: Will Curt Hitch Fit 2026 Hyundai Santa Fe Hybrid
- Q&A: What Hitch and Wiring Will Fit My 2026 Subaru Outback Wilderness?