Gauge Steel Used in the CE Smith Stake Pocket Part # CE45004G
Updated 07/15/2016 | Published 07/14/2016
Question:
How thick is the stake pocket? What gauge?
asked by: Gene
0
Expert Reply:
The galvanized steel used for the CE Smith stake pocket part # CE45004G that you referenced is 11 gauge.
That would mean that the thickness is .1196 inch.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
CE Smith Stake Pocket for Flatbed Truck or Trailer - Galvanized Steel - Bolt On - Qty 1
- Trailer Tie Down Anchors
- Stake Pockets
- Galvanized Steel
- Bolt-On
- Fixed
- Surface Mount
- CE Smith
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: 2X4 Stake Pocket That Does Not Require A Tapered Stake
- Q&A: How Many Weld-On Stake Pockets # HW03-080 to Install on Each Side of 12-Foot Trailer
- Q&A: 1/2" Receiver Pin Lock for Bike Racks in Large 2" Receiver Hitch
- Q&A: Parts Needed To Convert Trailer From Electric Drum Brakes To Electric Over Hydraulic Disc Brakes
- Q&A: Base Rail Mounting Kit for Thule TracRac SR to Fit Rear Stake Pockets on a 2018 Chevy Silverado 1500
- Q&A: Stake Pocket D-Ring Tie Down For Non-Standard 2-5/8"x1-9/16" Stake Pocket Hole
- Q&A: Suspension Stabilization For Trailer on '73-'87 Chevy 3/4 Bed Converted to Trailer
- Article: How to Measure a Trailer Axle
- Article: How to Raise Your Travel Trailer Height
- Article: Choosing the Right Suspension Kit for Your Truck and Trailer
- Article: Boat Trailer Guides: Which are the Best?
- Article: Trailer Tire Sizing
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: Trailer Drum Brakes vs. Disc Brakes: Making the Decision