Wire Colors by Function on Optronics Double Bullseye Clearance and Side Marker Light Part # MCL46RB
Published 09/15/2010
Question:
with a 2 wire side marker for a trailer, which wire is considered the hot wire, white or black?
asked by: Wayne
0
Expert Reply:
With the Optronics Double Bullseye Clearance and Side Marker Light, part # MCL46RB, the white wire with the ring terminal is the ground wire. Ground that wire to the trailer frame. The black wire is the hot wire, and should be tapped into the running light circuit.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Optronics Double Bullseye LED Trailer Clearance or Side Marker Light - 10 Diodes - Red Lens
- Trailer Lights
- Clearance Lights
- Marker
- Rectangle
- Surface Mount
- Non-Submersible Lights
- LED Light
- 4-1/16L x 2-1/8W Inch
- Red
- Optronics
more information >
Continue Researching
- Q&A: Direct Replacement Water Heater for Atwood Model GC10A-4E
- Q&A: Replacement Hub/Drum For Lippert Hub Stamped 122093
- Q&A: Why Are 5th Wheel Wiring Harnesses So Long?
- Q&A: Using A Marker Light With Two Wires To Replace Old Light That Only Had One Wire
- Q&A: Replacement Trim Rings for Ford OEM 5th Wheel Hitch
- Q&A: Replacement Battery and Battery Box for Hopkins Engager Trailer Breakaway System
- Q&A: The Yellow Charge Light Stays On Even When Trailer Disconnected on Engager BreakAway Kit
- Article: Trailer Lighting Requirements
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: How to Charge a Trailer Battery While Driving: 3 Common Problems (And How to Fix Them)
- Article: Is It Illegal to Leave My Hitch on My Truck?
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Article: 5 Tell-Tale Signs It’s Time to Replace Your Trailer’s Leaf Springs
- Article: Dealer Spotlight - Hamilton Trailer Repair