1990 Big Foot Slide Truck Camper Replacement Red and Amber Clearance Lights

Updated 06/03/2016 | Published 06/02/2016

Products Featured in This Question

Optronics Clearance and Side Marker Trailer Light - Submersible - Incandescent - Round - Red Lens

(2577)

$3.12

Right Angle 2-Wire Pigtail for Optronics Trailer Lights - 2-Prong PL-10 Plug - 6" Lead

(702)

$4.44

Rubber Grommet for 2-1/2" Round Trailer Lights - Flush Mount - Open Back

(115)

$4.44

Optronics Clearance and Side Marker Trailer Light - Submersible - Incandescent - Round - Amber Lens

(2577)

$3.42

Question:

Hello, Im looking to replace all the marking lights, 8 Red, 6 amber, approx. 2 to 2-1/2inch is the size. Current wiring in good condition however grounded to the screw base with a ring terminal and plugged into the rear of the light. 2 wire system, The camper is total fiberglass unit so no metal anywhere except the old brass receptacle and mounting screw. The lights are flush mounted with the mortite sealing and the holes are just large enough for not much wire. I see you have mounting kits, wondering if you could supply me with the correct part #s for all the components. Grommet/wiring etc. will I have to enlarge my current holes where wiring is coming through??? to use the grommets shown compatible with my recently viewed selection

asked by: Neal F

Expert Reply:

The red light part # MC55RB would be a 2-1/2 inch diameter light that would work well for the red lights you need to replace. For the amber version you would want the # MC55AB.

The grommet needed is the part # A55GB. For a pigtail harness you would want the part # A46PB.

This comes with a ground and power wire. You would need to route the white wire to a ground wire since your trailer is made of fiberglass. The black wire is the power wire.

The grommet requires a 3 inch hole to be drilled so you may need to enlarge what you have.