Can a 4 Inch Bumper Strip be Used in Place of One that Sticks Out 3 Inches
Published 04/29/2016
Question:
I have a 2006 Exiss Sport Horse trailer that I need rear bumper for however the dimensions that I have from my trailer differ from those on your website my bumper is 4inch high at the rear and only 3inch from rear to front of bumper. My total length is 74.5inch and my holes are 11inch OC, can I use the bumper that you show on my trailer?
asked by: Greg W
Expert Reply:
The Pre-drilled round rubber bumper # D4-96 is going to stick out a little further than the old bumper you have but it will still work. The length would have to be trimmed down since the new one is 96 inches. The mounting holes are spaced 11 inches apart on center on the new one as well so it will work on your trailer.
Product Page this Question was Asked From
Pre-Drilled Round Rubber Trailer Bumper - 96" Long x 4" Wide
- Trailer Door Parts
- Ramp Door Bumpers
- Bumper Strip
- Bolt-On
- 4 Inch Wide
- 96 Inch Long
- Rubber
- Redline
more information >
Continue Researching
- Q&A: What hardware is used to attach the 96inch predrilled rubber bumpers?
- Q&A: How Wide is the Curt Weight Distribution Shank C17132?
- Q&A: Recommended Ramp Door Transition Plate That Can Handle a Pallet Jack
- Q&A: Will Round Rubber Trailer Bumper Fit Trailer With 12 Inches Between Mounting Holes
- Q&A: Replacement Motor for Klauber Slide Out Motor K01431B300
- Q&A: Replacing A B&W Tow & Stow Hitch Ball Two Ball Assembly With Larger Ball
- Q&A: Can I Extend My Hitch Without Using TorkLift Hitch and SuperTruss Extension
- Article: Trailer Maintenance Schedule
- Article: Slipper Spring Trailer Suspension System Review
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide
- Article: How to Choose the Right Trailer Hitch Class
- Article: Trailer Wiring Diagrams
- Article: Brake Controller Installation: Starting from Scratch
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)