What is the Mounting Hole Diameter for the Erickson tie Down Anchors EM09095
Updated 04/29/2016 | Published 04/25/2016
Question:
What metric diameter panhead screw is goingto fit the holesin the anchor plate?I just ordered the the loops
asked by: Steve B
Expert Reply:
You would want to use countersunk screws since the holes in the Erickson tie down anchors # EM09095 are countersunk. I went out to the warehouse and pulled one of these anchor sets to measure the diameter of the hole width for the head and threaded part of a screw. For the threaded part of the screw use a 5mm. The countersunk head can be as large as 8.75mm in diameter. A 9mm diameter head would be too large for the screw head to sit flush with the top of the anchor.
Product Page this Question was Asked From
Erickson Stainless Steel Truck or Trailer Anchor (2 Pack) - 1,200 lbs
- Trailer Tie Down Anchors
- Rope Rings
- Universal
- Stainless Steel
- 1200 lbs
- Bolt-On
- Fixed
- Surface Mount
- Erickson
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Converting Your RV Water Heater to Tankless
- Q&A: Dimensions Between Bolt Holes for the CargoSmart 1/2" Anti-Rattle D-Ring Tie-Down Anchor
- Q&A: Is 14" Galvanized Wheel or 14" Silver Powder Coat Wheel Recommended for Boat Trailer
- Q&A: Recommended 4-Leaf Spring Replacement for a 1963 Silver Streak TT
- Q&A: Recommended Hangers for Slipper Spring Suspension
- Q&A: What Grade Bolts to Install Demco A-Frame Cast Head Coupler
- Q&A: What Is The DIffference Between The Brophy Stake Pocket Tie Down Anchors TL1B And TL2B?
- Q&A: What is the Fuse Rating and Power Wire Gauge Used for Trailer Wiring Harness # 118571
- Article: How to Install E-Track in 3 Easy Steps