Mounting Hole Dimensions for the Lunette Ring with 4 Hole Base # C48550
Updated 04/25/2016 | Published 04/21/2016
Products Featured in This Question
Question:
Can you provide drawing for hole placement? Only lists one dimension. 63023
asked by: Justin K
0
Expert Reply:
I contacted the manufacturer and found that the mounting hole dimensions of the Lunette Ring with 4 Hole Base, item # C48550, are 4-1/2 inches up and down and 4-1/2 inches left to right. The holes are 5/8 of an inch in diameter. They use the hardware kit # C48332.
I attached a diagram with these dimensions for you to check out as well.
expert reply by:
Jameson C
0
click to enlarge
Product Page this Question was Asked From
Curt Lunette Ring - Flat Plate Mount - 2-1/2" Diameter - 35,000 lbs
- Lunette Ring
- Coupler with Bracket
- Bolt-On
- 35000 lbs GTW
- 2-1/2 Inch Lunette Ring
- CURT
more information >
Continue Researching
- Q&A: Bolt Pattern of Buyers Products 3" I.D. Heavy-Duty Forged 4-Bolt Mount Lunette Ring # 337BDB1385
- Q&A: Recommended Hitch for a 2025 Subaru Forester Hybrid
- Q&A: Recommended Replacement Strut for a Snowmobile Trailer
- Q&A: Bolt Torque for Curt Lunette Ring - Flat Plate Mount - 2-1/2" Diameter - 35,000 lbs
- Q&A: Curt # C48560 vs Buyers Products # 337BDB1394 Lunette Ring Comparison
- Q&A: Width of Lippert LC733932 Solid Step RV Steps
- Q&A: How Much Do the Power Mountain Tallboy Off-Road Bottle Jacks Weigh?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: Trailer Wiring Diagrams