Will Erickson # EM07435 Loading Ramp Work for Loading Push Mower Into Truck Bed
Updated 04/19/2016 | Published 04/17/2016
Question:
My 2016 Chevy Colorado tailgate is 34 inches from the ground. Will this ramp work for me to load my push lawnmower?
asked by: D A
0
Expert Reply:
The Erickson # EM07435 loading ramps you mentioned would be ideal for getting your push mower up into the bed of your truck.
The ramps are relatively light, at around 15lbs apiece, and are constructed of zinc plated steel for corrosion resistance. The ramp features a non-skid surface that'll make it easier to keep your footing while loading your lawn mower.
expert reply by:
Mike L
0
Product Page this Question was Asked From
Erickson Arched Loading Ramp Set - Steel - 72" Long x 9" Wide - 1,000 lbs
- ATV Ramps
- Ramp Set
- Tri-Fold
- 9 Inch Wide
- 1000 lbs
- Arched
- 72 Inch Long
- Steel
- Erickson
more information >
Continue Researching
- Q&A: Recommended Trailer Fenders for Tandem Axle Trailer W/ 15" Wheels
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: How to Charge a Dump Trailer Battery
- Q&A: Recommended Front Mount Trailer Hitch Receiver for 2015 Toyota Tacoma
- Q&A: What is the Trailer Tire Metric Equivalent to a 4.80 x 12 Trailer Tire
- Q&A: Can the Thule Hullavator Be Used with a Malone AirFlow2 Roof Rack
- Q&A: Can Furrion Chill Cube AC Unit Be Used To Replace Coleman Mach AC?
- Q&A: Can Furrion Chill Cube RV Air Conditioner Replace 9k Btu AC On Camper
- Q&A: Does Furrion Chill Air Conditioner Fan Run Constantly on Cooling Mode
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Article: Troubleshooting Brake Controller Installations