Parts Needed to Install a P2 Brake Controller in a 2003 Ford Windstar
Updated 04/13/2016 | Published 04/10/2016
Products Featured in This Question
Question:
I have a prodigy p2 brake controller but I cant find the harness to plug the brake controller into, where is it located?
asked by: Todd
Expert Reply:
There isn't a brake controller harness for a 2003 Ford Windstar so the controller has to be hardwired into the vehicle.
If your van currently does not have a trailer connector you will start by adding a 4-Way flat using # 36345 if your van was built after October 2002 or # HM40615 if it was built before November 2002.
After the 4-Way is installed, or if the van already has one, you will need to use the 4- and 7-Way installation kit # ETBC7. This provides a 7-Way, retains the 4-Way, and has the wiring and accessories needed to install the brake controller. I have included some links that show and explain the ETBC7 installation for you.
Featured Help Information
Miscellaneous Media
Continue Researching
- Article: Brake Controller Installation: Starting from Scratch
- Q&A: How to Test Brake Controller without Trailer Connected
- Article: Best Bike Racks for Electric Bikes
- Article: Towing a Trailer? Let's Talk About Brake Controllers
- Article: 2005-Current Volkswagen Touareg, Audi, or Porsche Cayenne
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Q&A: Dexter Brake Assembly Recommendations to Replace Part Number 023-357-00