Effect on Ride and Ride Height of Super Springs SuperCoils for 2015 Ram 2500 4WD, Front Axle

Question

Question:

How will these springs effect the ride of the truck. Will it only lift the front 2inch not any more.

asked by: Bruce

1

Helpful Expert Reply:

The Super Springs SuperCoils Custom Suspension Coils # SSC-25 are desinged to upgrade your vehicle's front suspension. With the upgraded suspension, the ride will likely get a bit stiffer, as the SuperCoils work to take bounce out of the vehicle's suspension.

The SuperCoils are not designed as a leveling kit, but the nature of the springs will increase the vehilce's ride height by approximately 2 inches.

These springs are great for trucks with bumper guards, snowplows, or armored plating that add weight and can cause front end vehicle sag.

The SuperCoils # SSC-25 are confirmed as a fit for the front axle of the 2015 Ram 2500 with 4 wheel drive. The installation instructions for these coil springs are attached.

expert reply by: Victoria B

1

Answer 1

We can definitely help set you up! There is a front mount hitch available for the 2024 Ram 2500 with the Curt #C73ZV. It will be a direct bolt-on install and some minor trimming of the bumper fascia may be required. As far as front suspension…

view full answer...

Answer 2

There aren't too many options for front end suspension enhancement, however we do offer front coil springs designed for trucks with snow plows part #SSC-25. This is a great upgrade to make the front suspension more rigid.

view full answer...

Answer 3

The difference between the Class II and Class III hitches has to do with their Gross Trailer Weight (GTW), their Tongue Weight (TW), and their Hitch Receiver Size. Class II trailer hitch receivers have a 1-1/4 inch receiver and can be rated up to…

view full answer...

Answer 4

In order to determine the torque rating for the lug nuts on your trailer you will need to know check out the chart I attached that shows all of the torque specs for all the trailer lugs available based on stud size, wheel material and wheel size.

view full answer...

Answer 5

A 4-Way trailer connector has the basic lighting functions only; running lights, left turn signal and brake lights, right turn signal and brake lights, and ground. A 7-Way has these functions and a 12 volt circuit, a circuit for electric trailer…

view full answer...

Answer 6

Since the pin weight of your camper is 2.1k, I recommend going with the LoadLifter 5000 opposed to the 7500. While technically there is not reason you couldn't use the 7500 kit, it really is not necessary for a camper like yours. Generally the…

view full answer...

Answer 7

Yes, it will work. You'll just need to cut the Lance 6-pin connector out and rewire it into the etrailer Trailer Wiring 7-Way Upgrade Kit w/ Junction Box and RV Style Connector item #e99011. Here are the individual functions of that Lance 6-pin:…

view full answer...

Answer 8

The OEM prep package consists of 4 "pucks" in the bed of the truck that will allow you to drop in puck style hitches for easy installation and removal, that gives you a completely clear bed when not in use. The B&W Companion OEM 5th…

view full answer...

Answer 9

You will have to go with a sliding hitch to allow the trailer to make tight turns. For a trailer 8 feet wide the only bed length that's going to allow 90 degree turns without a slider is a stationary hitch. That being said you have two options.…

view full answer...

Answer 10

The main difference between the Curt Trailer Hitch Receiver part #C13416 and the EcoHitch Hidden Trailer Hitch Receiver part #EH97FR is that the EcoHitch has a completely hidden cross tube whereas the Curt cross tube will be visible from the rear of…

view full answer...

Answer 11

Hi David! There are quite a few hitches offered for your 2026 Honda Odyssey, so I definitely understand wanting to know the differences. There are basically three styles available for you and I have them broken out below: Exposed Crosstube: etrailer…

view full answer...

Answer 12

Hey Ricardo! Yes, the Curt Trailer Hitch Receiver #C82RJ is the hitch Curt is working on for the new 2027 Telluride. This is a pre-order since Curt hasn't finished the design. It does not include wiring. The wiring harness for the 2027 is also up…

view full answer...

Effect on Ride and Ride Height of Super Springs SuperCoils for 2015 Ram 2500 4WD, Front Axle

Product Page this Question was Asked From

Featured Help Information

Instructions

Continue Researching