Loading Ramp Recommendation for Loading a Raven MPV7100 Onto a Utility Trailer
Question:
Have a Raven MPV7100 weight unknown sitting on a Lifetime Trailer, model 65049, with no means of getting it off the trailer on to the ground. Need ramps.
asked by: Peter H
0
Expert Reply:
Sounds like you are looking for a loading ramp set like the Erickson part # EM07435. These are 72 inch long ramps that are 9 inches wide and have a 1,000 lb capacity.
Your Raven MPV7100 is pretty heavy, but it does not weigh more than 1,000 lbs so this ramp set would work well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Erickson Arched Loading Ramp Set - Steel - 72" Long x 9" Wide - 1,000 lbs
- ATV Ramps
- Ramp Set
- Tri-Fold
- 9 Inch Wide
- 1000 lbs
- Arched
- 72 Inch Long
- Steel
- Erickson
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Can Furrion Chill Cube AC Unit Be Used To Replace Coleman Mach AC?
- Q&A: Can Furrion Chill Cube RV Air Conditioner Replace 9k Btu AC On Camper
- Q&A: Replacement For Dometic Brisk II on 2012 CrossRoads Elevation
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?
- Article: How to Charge a Dump Trailer Battery
- Q&A: Is The Furrion Chill Cube AC Unit Available Aftermarket?
- Q&A: Replacement AC Options For A 1999 Fleetwood Prowler
- Q&A: What is the Trailer Tire Metric Equivalent to a 4.80 x 12 Trailer Tire
- Q&A: Can the Thule Hullavator Be Used with a Malone AirFlow2 Roof Rack
- Article: Best Vehicles to Flat Tow Behind an RV
- Article: Roof Rack Information
- Article: How to Measure Your Trailer Wheel Bolt Pattern
- Article: RV Sway Control, Stabilization, and Suspension Enhancement
- Article: Troubleshooting Brake Controller Installations