Trailer Jack Recommendation for a Trailer with only 3 inches of Available Frame Space
Updated 03/21/2016 | Published 03/19/2016
Question:
i have very limited room to place a tongue jack, about 3 inches. can i Use U bolts and brackets to attach one of the weld on jacks?
asked by: Brian M
0
Expert Reply:
A swivel pipe-mounted jack like the Pro Series part # PS1401460303 can mount to a trailer frame and since the pipe that welds to the frame is only 2 inches wide it would fit on your trailer frame that only has 3 inches of clear space.
I attached a review video for this jack for you to check out as well.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Pro Series Round, Pipe-Mount Swivel Jack w/ Footplate - Topwind - 10" Lift - 5,000 lbs
- Trailer Jack
- Car Hauler
- Enclosed Trailer
- Utility Trailer
- Side-Mount Jacks
- Swivel Jacks
- Standard Grade
- 4001 - 5000 lbs
- Manual Jack
- 10 Inch Lift
- Weld-On
- With Rectangle Foot
- Pro Series
more information >
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Is Furrion Vision S+ Direct Replacement for Vision S
- Q&A: What Comes With The etrailer Swivel Jack w/ Bolt-On Mounting Plate # e54RV
- Q&A: Is There Smaller 12 inch Trailer Tire that is Radial
- Q&A: Trailer Pipe Mounted Swivel Jack with Retracted Length Measurements
- Article: Determining Trailer Tongue Weight
- Q&A: Comparing The Curt # C32NR and Hopkins # HM40978 Mounting Brackets
- Q&A: Will Pro Series Jack # PS1401460303 Fit etrailer Pipe Mount # e52JR
- Article: Trailer Couplers
- Article: How to Measure for Trailer Hitch Drop
- Q&A: Replacement Wet Suspension Bolt Recommendation for Montana Trailer with Lippert Correct Track
- Article: How to Mount a Truck Bed Camper
- Article: Trailer Lighting Requirements
- Article: Where to Position the Trailer Axle?
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)