Can Friction Sway Control be Used on an Aluminum Frame Trailer
Updated 02/08/2016 | Published 02/07/2016
Question:
is it recommended to use friction sway on a aluminmum toy hauler trailer dry weight is 5470 LBS.Towing with F 350 6.2l
asked by: Walton G
0
Expert Reply:
Friction sway control units like the part # 83660 require drilling into the frame of the trailer for installation. You would need to contact the manufacturer of your trailer to determine if they are okay with you doing that on your trailer. Most likely you would be fine, but you still need to check since aluminum trailer frame manufacturer are a bit more particular than steel frame trailers.
expert reply by:
Jameson C
0
Product Page this Question was Asked From
Reese Friction Sway Control Kit - Economy - by Draw-Tite, Reese and Hidden Hitch
- Weight Distribution Hitch
- Sway Control Only
- Reese
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: 5 Things to Know About Weight Distribution Hitches
- Q&A: What Ohms Should Trailer Brake Magnets Be?
- Article: The Best Trailer Tongue Locks for Preventing Trailer Theft
- Q&A: Replacement For Hub & Drum 8-207
- Article: Holiday 2025 | Best Gifts for RVing
- Q&A: Troubleshooting Curt TruTrack Not Leveling Truck After Installation and Maximum Adjustment
- Q&A: Where to Install Transmission Cooler on a 2006 Toyota Sienna
- Q&A: U-Bolt Torque Recommendation for 1/2 inch Diameter On Trailer Suspension
- Q&A: Recommended Replacement for Imperial 55 Inch Side-Door Bar Lock
- Article: Trailer Lighting Requirements
- Q&A: Can I Get Key 0370 For The Master Lock Coupler Lock ML377KA
- Article: 30-Amp and 50-Amp RV Service: What's the Difference?