How Do I Install Timbren Rear Suspension Enhancment System TJRL4 on a 2007 Jeep Liberty

Updated 07/23/2010 | Published 07/22/2010

Question:

i have just recieved my timbren rubber shock asborbers and i only recieved the timbren rubbers i have not recieved any specific bracket for the jeep. i removed the coil spring and the factory bump stop and try putting in the timbren it is rather difficult. i also separated the hollow rubbers from the top part and it is still very difficult. i just want some advice on how to get it into the bump stop hole. the hole has four small wedges in it and it hard to get that rubber into them.

asked by: lenny n

Expert Reply:

There are no brackets needed for this kit. The rubber Aeon spring fits into the pre-existing bump stop cup. It is made to be a very tight fit. The factory bump-stop is there to cushion the blow of anny sudden or over-loaded suspension travel. As such it needs to be held firmly in place and not allowed any wiggle room. Twist the spring as you push it up to make sure it is firmly seated in the cup, and then bolt it into place.

expert reply by: Patrick B