Where Should Flexco Manual Pull-Out Steps Be Mounted on Horse Trailer
Published 01/28/2016
Question:
Can I mount the pull out steps to the running board of my horse trailer?
asked by: Tabatha
0
Expert Reply:
The Flexco Manual Pull-Out Steps # SMFP-2120 should be mounted to the frame of the trailer. Steps need to be mounted to the frame, rather than an additional component like the running board, to ensure the steps are properly supported when in use.
If you decide to mount these steps to your frame, they can either be bolted or welded on. Four carriage bolts and nuts, not included, will be needed to bolt the stairs to the frame.
expert reply by:
Victoria B
0
Product Page this Question was Asked From
Flexco Manual Pull-Out Steps for RVs - Double - 8" Drop/Rise - 20" Wide - 300 lbs
- RV Steps
- Towable Camper
- Pull-Out Step
- 20 Inch Wide Step
- 23-5/8 Inch Wide
- 2 Steps
- 8 Inch Drop/Rise
- 19 Inch Entry
- 20 Inch Entry
- 21 Inch Entry
- 22 Inch Entry
- Steel
- Stromberg Carlson
more information >
Continue Researching
- Q&A: How To Install Lippert Outriggers To Your RV To Install New Pull Out Steps
- Q&A: Picture of the TorkLift Scissor Steps Stowed
- Q&A: Gap Between First/Last Step and Mounting Plate on TorkLift GlowStep Stow N' Go Scissor Steps
- Q&A: Do Torklift Glowsteps Require Tools to Remove/Install from Mounting Bracket
- Q&A: 2 Step Pull Out Recommendation for a 2016 Wildwood Forest River Camper
- Q&A: Replacement 2-Step RV Steps For A 2017 Forest River Wildwood 171RBXL Travel Trailer
- Q&A: How to Determine Correct Replacement Step For RV
- Article: Trailer Wiring Diagrams
- Article: Which Sway Control Hitch is Right For Your Trailer?
- Article: The Best Electric Trailer Jacks of 2025
- Article: How to Measure for Travel Trailer and Fifth Wheel Steps
- Article: Wiring Trailer Lights with a 7-Way Plug (It's Easier Than You Think)
- Article: 4-Step Guide to Installing RV Solar Power
- Article: Is It Illegal to Leave My Hitch on My Truck?