Dimension of Pin Hole on Curt Class III Hitch Receiver
Published 12/30/2015
Products Featured in This Question
Question:
What is the diameter of the hole in the hitch for the hitch pin? The hole diameter in the hitch ball mount is 5/8
asked by: John
0
Expert Reply:
Good news, I can help you figure out which hitch pin you will need for your Curt Hitch # 13160.
The # C21504 is the recommended hitch pin for your 2 inch Curt Class III Hitch. The pin measures 5/8 inches wide, and the diameter of the hole on the hitch is 5/8 inches as well.
If you would like to get a locking hitch pin to secure the item you are transporting from theft, I would recommend the etrailer # e98882.
expert reply by:
Jackie C
0
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class III - 2"
- Trailer Hitch
- For Towing
- Class III
- 500 lbs TW
- 5000 lbs GTW
- 6000 lbs WD GTW
- 2 Inch Hitch
- 600 lbs WD TW
- Visible Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: Replacement Installation Hardware Kit for Curt Class III Hitch Part # 13160
- Q&A: Replacing 6-Way on Trailer With 7-Way Connector
- Q&A: Can 1985 Coleman Chesapeake Tent Trailer go to Tire Size 5.3-12
- Q&A: What is Towing Capacity of 1999 Jeep Cherokee Sport
- Q&A: Does Skid Plate Need To Be Removed To Install Draw-Tite Front Mount Hitch On 1993 Jeep Cherokee?
- Article: How to Choose the Right Trailer Hitch Class
- Q&A: Replacement Hardware For Curt Trailer Hitch on 2000 Jeep Cherokee
- Q&A: Replacement Hitch Hardware for 1999 Jeep Cherokee
- Article: Rooftop Cargo Carriers
- Article: Troubleshooting 4 and 5-Way Wiring Installations
- Article: Brake Controller 7- and 4-Way Installation Kit (ETBC7)