Dimension Thickness of Front Element Seal for Access Toneau Covers
Published 11/24/2015
Question:
What is the width of this seal
asked by: Ken
0
Expert Reply:
I was able to pull this from our warehouse and found out that the thickness of this varies.
On the adhesive side of the strip the thickness of the foam is .162 inches thick, with the tape it is .205 inches thick. The thickness of the foam on the side without the adhesive is .182 inches.
The height of the foam from the adhesive side to the edge is .725 inches and the non-adhesive side to the end is .638 inches.
I have attached diagrams of the measurements I have taken for you to get a better idea of which side is which.
expert reply by:
Jackie C
0
click to enlarge
click to enlarge
Product Page this Question was Asked From
Access Front Element Seal for Tonneau Covers - Universal Fit
- Accessories and Parts
- Tonneau Cover
- Seals and Gaskets
- Access
more information >
Featured Help Information
Instructions
Continue Researching
- Article: Thank you!
- Q&A: How can the Tailgate be Unlocked if the Pop and Lock Powered Tailgate Lock Fails
- Article: How to Measure for Trailer Hitch Drop
- Q&A: How to Remove B&W Companion 5th Wheel Hitch from Turnover Ball Goosneck Hitch
- Q&A: Recommended Roll Up Bed Cover For A 2022 Chevy Silverado 2500 With Multipro Tailgate
- Q&A: How To Lock Base On B&W Companion OEM 5th Wheel Hitch
- Q&A: How to Replace the Header Seal on the TruXedo Lo Pro Soft Roll-Up Tonneau Cover
- Q&A: Does Truck with 6-1/2 ft bed Have to Use Slider Hitch for Turning Clearance with Fifth Wheel Hitch
- Q&A: Above vs Below-Bed Hitches and Recommended Hitch for 2018 Ford F-350 with 6.75-Foot Bed
- Article: Rooftop Cargo Carriers
- Article: How Much Solar Power Do I Need For My RV?
- Article: 4 Reasons Not to Use RV Solar Power (And 4 Reasons You Should)
- Article: Performance Chips and Modules