Replacement Landing Gear With Drop Leg Recommendation for Trailer with Unknown jacks
Updated 11/24/2015 | Published 11/23/2015
Question:
Have a goose neck with tandem jacks. The jacks have no label and one of the jacks is bad. I am looking to replace it with the pro series. Can I use this Jack with another?
asked by: Matt
0
Expert Reply:
Based on the design of the drop leg and the markings on the side of the jack the picture you submitted is of a Bulldog jack part # BD182400. If you are looking to replace just one of the jacks you would need this part number.
expert reply by:
Jameson C
0
click to enlarge
Featured Help Information
Miscellaneous Media
Continue Researching
- Q&A: Recommended Replacement Weld On Jack with 10,000 lb Capacity
- Q&A: Technical Diagram Of 10000lb Pro Series Square Jack - Drop Leg w/ Spring Return
- Q&A: How To Determine If Boat Trailer has 10 Inch or 12 Inch Brake Assemblies
- Article: Trailer Wiring Diagrams
- Q&A: Can Wheel Studs Be Installed in Trailer Hub That Uses Wheel Bolts
- Q&A: Connecting Rod for 25K etrailer Square Heavy Duty Jacks
- Article: Breakaway Kit Installation for Single and Dual Brake Axle Trailers
- Q&A: How to Replace Interior Ram Jack Rod and Nut # TJD-12000-RODNUT on 12000 Series Jacks
- Q&A: Trailer Jack Recommendation For 14,000 Lb A-frame Dump Trailer
- Article: Trailer Jacks
- Article: Slipper Spring Trailer Suspension System Review
- Article: Double-Eye Trailer Suspension System Review
- Article: How to Adjust Your Trailer Brakes | The Ultimate Guide