Is Cutting or Modifying the Bumper Required to Install a Trailer Hitch on a 2009 Volkswagen Eos
Updated 06/28/2010 | Published 06/25/2010
Products Featured in This Question
Question:
Do I have to cut a hole in the bumper on my 2009 VW Eos.
asked by: Cheryl
Expert Reply:
Good news. You will not have to cut or modify the bumper or rear fascia in any way to install the Curt Trailer Hitch, # C11090, on your 2009 Volkswagen Eos. You may have to trim or bend a heat shield so the hitch will fit properly. I have included a link to the installation instructions below.
The recommended ball mount for this hitch is # 3594. Use only the recommended ball mount and it should only be used in the rise position. For a hitch ball, you can use # 19256 (1-7/8 inch diameter) or # 19258 (2 inch diameter) depending on your towing needs. I also recommend a locking hitch pin, # e98879, to secure the ball mount and deter theft.
The recommended trailer wiring is the 4 Pole Harness and Hardwire Kit, # C59496. I have included a link to the installation details below.
Product Page this Question was Asked From
Curt Trailer Hitch Receiver - Custom Fit - Class I - 1-1/4"
- Trailer Hitch
- For Towing
- Class I
- 100 lbs TW
- 1000 lbs GTW
- 1-1/4 Inch Hitch
- Concealed Cross Tube
- CURT
more information >
Featured Help Information
Instructions
Continue Researching
- Q&A: How Thick Are Electric Brake Shoe Pads and When Should They be Replaced
- Q&A: Outside Diameter Of Curt Trailer Hitch Receiver # C11114
- Article: Trailer Wiring Diagrams
- Q&A: J-Case Fuse Position For Curt 7-Way Harness On 2024 Honda Pilot Blocked
- Q&A: What Should the Voltage Output Be at the 4-Way Plug on Curt T-Connector Wiring Harness # 56016
- Q&A: Availability of EcoHitch Front Hitch Installation Video With Active Air Dam Removal for 2024 F-150
- Q&A: Removing Rusted On Bolts for Trailer Hitch Installation
- Q&A: Solution for Weld Nuts of Trailer Hitch that Are Too Rusty to Thread Bolts